Taking the energy away from the valve will close it and stop the flow. For more information go to BZW-10 of our brass valve line is a two-way, semi-direct lift valve with a normally closed operating position. This means that there are two ports in which media flows and the valve will open when energized to allow media to pass through.

WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. If energized continuously for more than 8 hours the coil may burn. The coil will reach a maximum temperature of about 176☏ (80℃), which is fully complied with national standard: JB/T7352-2010. While energized, under normal operating conditions, solenoid valve will get HOT. OVERHEATING WARNING: Not designed for continuous operation(not a 100% duty cycle). Temperature Maximum: 176 degrees Fahrenheit (80 degrees Celsius) Temperature, Minimum: 23 degrees Fahrenheit (-5 degrees Celsius)

Operational pressure range: Air/Water: 0-7 Bar (0 to 101 PSI) Oil: 0-5 Bar(0 to 72 PSI)įlow capacity: 0.23 gallons per minute (GPM) of water at 60 oF with a pressure drop of 1 PSI Suitable Media: Air, water, diesel oil, kerosene, etc. Customers chose this general purpose valve for: do-it-yourself projects, moderate temperature applications, water exchange for aquarium, air horn, or bleeding moisture from an air tank. However, if permanently installed outdoors, it is recommended that you enclose the valves in some protective housing.

Suitable for use with hot or cold water, gas, air, very low viscosity fluids (< 20 cst), oils and hydrocarbons, e.g., gasoline, kerosene, or diesel fuel. The solenoid valves have a rating of IP65, which means they can withstand spray from water. Solid normally closed (N/C) electric solenoid valve is constructed with a durable brass body, two-way inlet and outlet ports with one-quarter inch (1/8') female threaded (NPT) connections, and heat and oil resistant NBR seals.

Dc 12v electric solenoid valve